Aligning the machine is an additional difficulty in the slope alignment of the drilling arm.
It’s difficult to drill parallel holes with only marks on the ground.
It’s nearly impossible to drill all holes to the same depth without any measuring system.
The manual measurement is time consuming and therefore exensive.
If the boreholes are drilled in the wrong position, explosions may result in rockfall and a dirty break-off edge.
It’s difficult to drill all the holes at the same angle.
Drilling system for precise blast hole boring
With MOBA’s MDS-1000 drilling system, you can prepare your blast with precisely measured, uniform drill holes and immediately increase your cost efficiency. Save yourself time-consuming manual measurements and drill perfectly parallel holes of the same depth and angle in just a few simple steps with the assistance of the MDS-1000 system.
High-end drilling system with programmable graphic display
The high-end MDS-2000 drilling system from MOBA allows you to prepare your blast with precisely measured, uniform drill holes and increase your cost efficiency immediately. Save time-consuming, manual measurements and drill parallel holes of the same depth and angle in just a few steps with the assistance of the MDS-2000 system. Thanks to extraordinary modularity, you can also benefit from cost and time-efficient upgrades from a varied selection of additional components.